Apply a coating of contact adhesive (3M-10 Scotchgrip recommended) to the rubber and wood surfaces to be bonded. If the ball set is a not regulation then multiply 63% times the diameter of the ball and this will give you the correct nose height for the cushions.Ĥ. Measurement - test fit the new cushion by placing it on the rail and measure the distance from the nose of the cushion down to the slate When using a regulation ball set (2.25" dia) the best performance is achieved when the nose to slate distance is 1 7/16". Lightly sand the entire wood sub-rail (400 or higher grit onĪ sanding block) to assure a smooth and clean surface.ģ. That the cushion will be glued to and remove any old glue residue. Before installing new cushion rubber lightly sand the rubber side that will be glued to remove any mold release residue. If viewing from the side, the top side of triangle shaped cushion has a very slight curvature while the bottom side is flat.Ģ. Of the rubber so you are not installing it upside down. There should be some overhang at each end of the rail.
Do not cut the rubber to size prior to installation. We offer this product on the same page as our cushion sets. We recomment 3M-10 Scotchgrip adhesive for installing new cushions. If your cushions are not marked refer to the cushion dimensions shown here. Some tables use K55 and cheaper tables may use U23. Make sure to select the correct cushion profile for your table. (hard) and cushion replacement is necessary. If the rails are tight and the ball makes a thud sound or does not have an active rebound off the cushion then the cushion is either dead or dry rotted If they are loose they may play like they're dead. When considering cushion replacement first make sure your rails are mounted tight to the table.
#1960 valley pool table free
Get a free set of cushion facings with a pool table cushion set purchase on our Billiard Supplies Page. We carry Artemis Pool #66 (K66 profile) and ProForm K66, K55, U23 and Century profile pool table cushions.įor carom tables we carry ProForm K55 cushions at 120" nominal length.
0 kommentar(er)
